Techno Vector 7 - T 7202 T 5 A

DESCRIPTION
Number of cameras 2 stationary cameras
Camera type 5 MPix machine vision industrial cameras, RAW
Mounting type Floor-mount. T-shaped pillar
Cabinet type T-series
Applicability Lift or Pit
Distance from cameras to the center of front turn tables 1500-2500mm, recommended distance 2200mm
Main advantages

2-camera configuration is sufficient to organize a wheel alignment post on any pit;
Set of 5Mpix cameras allows a better use of the aligner on the lift*;
Does not need calibration and allows you to start working right after installation**.

 

* For lifts, the measurement height can be at approximately 900mm above the floor;
** Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement. 

INSTALLATION AND CALIBRATION
Mounting Required (floor)
Calibration after mounting Not required*

* Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement. 

Installation and calibration must be performed by a certified specialist. 
This wheel aligner is supplied pre-calibrated and can be used right after installation.