Techno Vector 7 - V 7204 T A

DESCRIPTION
Number of cameras 4 stationary cameras
Camera type 2x1.3MPix and 2x5MPix machine vision industrial cameras, RAW
Mounting type Floor-mount. T-shaped pillar
Cabinet type V-series
Applicability Lift or Pit
Distance from cameras to the center of front turn tables 1200-2550mm, recommended distance 2200mm
Main advantages
  • Does not need calibration and allows you to start working right after installation*;
  • 4 camera configurations allow using a lift throughout all its height**.

 

* Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement. 
** When installed at the distance of more than 2200mm from front turn tables, the wheel aligner works from the lowest position of the lift up to the height of 1700mm.

INSTALLATION AND CALIBRATION
Mounting Required (floor)
Calibration after mounting Not required*

* Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement. 

Installation and calibration must be performed by a certified specialist. 
This wheel aligner is supplied pre-calibrated and can be used right after installation.